This is an innovating system for which the architect needs a previous formation to enable him to design the buildings according to his knowledge and the characteristics of the system. The main difference of this system is the control in the progress of the works. The architecture bureau stays informed, at any time, from its office or any Internet point, of the progress of the works and verifies that deviations with respect to the project have not taken place. All the parameters are controlled and memorised, and thus there is total control of all the constructions that are being realised.

The control posts, among others, are the following:

Control of the cone of Abrams in draining of the autocompact concrete.

Formulation that is being realised in the concrete.

Control of breakage of test tubes in press with image and signal.

Control of the entrance of aggregates with the code decided previously at    the quarry, in the hoppers or plants of aggregates.

Control of temperature of the aggregates.

Humidity control of the aggregates.

Cement control with codes decided previously with the cement factory +    temperature of the same.

Time of mixing and homogenisation of the concrete and room temperature.

Retention time of the mixing in beater or pump after the mixing.

Temperature of concrete in pumping equipment.

Curing temperature of the concrete.

Cured temperature of concrete in frameworks or moulds.

Humidity in the atmosphere of curing in the inner chamber.

Curing time of the concrete.

Verification of concrete resistance with a digital sclerometer, before the    lifting of a piece or the taking away of moulds, or in the curing of the    double wall.

Positioning of all the props of security.

Control of type of steel with code of the supplier.

Control of the thickness of the steel used in the armours with codes in the    electro-soldering.

Temperature of water in satellite trucks.

Existence of litres of water in satellite trucks.